Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Hodgkinson on December 29, 2007, 03:28:50 PM

Title: Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) jumper settings
Post by: Hodgkinson on December 29, 2007, 03:28:50 PM

Hi there,
I have a A1200T with a Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) busboard installed. Unfortunatly, I have sinced removed the '030 card from the system (In order to build up another A1200) and the system will no longer boot.
Apparently, there are jumpers that determine wether the A4000 processor slot, A1200 accelerator, or the motherboard 68020 is used.

Does anyone have a manual or jumper information for this busboard?

Thanks,
Hodgkinson.

Title: Re: Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) jumper settings
Post by: Painkiller on December 29, 2007, 03:31:15 PM

Will this help?

http://amiga.resource.cx/photos/micronik1200z3

Aaa here is the manual:

http://www.amiga-hardware.com/downloads/busboardz3-66_e.lha

Title: Re: Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) jumper settings
Post by: Hodgkinson on December 30, 2007, 02:06:10 PM

Thats the board...I've downloaded the manual but for some reason I can't quite see how you managed to find the manual in the first place...
(I assume the manual is for the v6.6 to v6.8 boards, SCSI, no RAM?)

Thanks,
Hodgkinson.

Title: Re: Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) jumper settings
Post by: Gwion on December 30, 2007, 05:01:00 PM

Is that the board that was on ebay recently?

Title: Re: Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) jumper settings
Post by: Hodgkinson on December 31, 2007, 02:56:06 PM

Quote

Is that the board that was on ebay recently?

 :roll: I haven't looked on ebay in ages. The actual board that I have was mounted in a Micronik tower that I was given a while back.

Hodgkinson.