Amiga.org
		Amiga computer related discussion => Amiga Tutorials => Topic started by: roguebeck on October 05, 2007, 09:42:53 PM
		
			
			- 
				Anyone have a link to a tutorial to do a full/clean install of Amiga OS 3.9?
 
 Thanks again.
- 
				that should not be that hard to do is it?
 i always make a clean os3.1 install and upgrade from there
 but u can also make a emergency disk and boot from that
- 
				The tutorial area of Amiga.org has two tutorials on installing a basic 3.1 OS, that would be a good start. Once you install that, 3.9 is easy.
			
- 
				The tutorial area of Amiga.org has two tutorials on installing a basic 3.1 OS 
 eeem.... :-?  where can it be found?
 
 
- 
				I see, but I only have the OS3.9 cd.
 
 
 amazing wrote:
 that should not be that hard to do is it?
 i always make a clean os3.1 install and upgrade from there
 but u can also make a emergency disk and boot from that
 
- 
				Hmmm the tutorial for installing 3.1 seems to be missing. Any help here???
 
 
 
 pyrre wrote:
 The tutorial area of Amiga.org has two tutorials on installing a basic 3.1 OS 
 eeem.... :-?  where can it be found?
 
 
 
- 
				here u go
 http://www.cdv.co.nz/support/amiga/001/
- 
				Snap! I just searched and found the same one by InTheSand :-)
 
 The installation of Workbench 3.0 starts at page 11 (http://www.cdv.co.nz/support/amiga/001/11.php) The procedure for the install of 3.1 is exactly the same :pint:
 
 Hey! That makes 400 posts  :banana:
- 
				Good.
 
 The other tutorials are in the Forum area, and in the General section.