Amiga.org

Amiga computer related discussion => Amiga Software Issues and Discussion => Topic started by: sdyates on September 15, 2007, 01:38:21 AM

Title: Creating RDB Hardfile in UAE
Post by: sdyates on September 15, 2007, 01:38:21 AM

Ok, I created two hard files: one for system and one for work.

I followed the instructions: HDToolbox DEVICE uaehf.device and yet the Amiga emu does nto see the drives. There is not even a NDOS icon.

Am I doing this wrong?

I am using H-toro...

Thanks

Title: Re: Creating RDB Hardfile in UAE
Post by: Thomas on September 15, 2007, 10:22:51 AM

Quote

I created two hard files: one for system and one for work.

Why two ? If you use a RDB you can create two partitions in one HDF. That's what the RDB is meant for.

Quote

HDToolbox DEVICE uaehf.device

This should be hdtoolbox uaehf.device. In version 3.5 and above you *can* add DEVICE, but in earlier versions of HDToolbox, it *may not* be specified.

Quote

There is not even a NDOS icon.

There cannot be any icon before you have created at least one partition. There will be one icon per partition. No partition, no icon.

Quote

Am I doing this wrong?

Obviously  :-D

Bye,
Thomas

Title: Re: Creating RDB Hardfile in UAE
Post by: sdyates on September 15, 2007, 02:09:22 PM

Well that helps a lot. I was not sure I only needed on device(RDB). However, I tried the HDToolbox device uaehf.device and nothing showed up

Does anything else need to be done to HDToolbox for it to work?.