Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: StevenJGore on June 26, 2003, 01:17:28 PM

Title: Two questions about the CD32, FMV Module, and SX32 MK2
Post by: StevenJGore on June 26, 2003, 01:17:28 PM

Is it possible to have both my SX32 MK2 and my FMV module plugged into the CD32 at the same time, even if it means removing the FMV card from its metal shielding and backplate, or using a pass-through connector of some kind for the CD32's expansion slot?

Also, I can't get the SX32 MK2 to fit flush with the rear of the CD32 case. I have a gap of about 4-5mm round the backplate, the SX32 doesn't seem to fit far enough onto the connectors. Anyone any suggestions?

Many thanks in advance guys,

Steve.

Title: Re: Two questions about the CD32, FMV Module, and SX32 MK2
Post by: amiga1260 on June 26, 2003, 01:42:05 PM

Title: Re: Two questions about the CD32, FMV Module, and SX32 MK2
Post by: StevenJGore on June 26, 2003, 03:34:56 PM

Cheers!

Quote

amiga1260 wrote:
You have to find a special FMV-module for the SX32.

Is there such a thing?! They're probably even rarer than 'normal' FMV modules!

Title: Re: Two questions about the CD32, FMV Module, and SX32 MK2
Post by: ironfist on June 26, 2003, 06:16:20 PM

I have a by-pass card which I use for the FMV
and the SX-1 modules. It works fine, however I
have a slight recall that I can only use max 4 mb
RAM with the FMV attached. Otherwise the SX-1
supports 8 mb.

Title: Re: Two questions about the CD32, FMV Module, and SX32 MK2
Post by: JohnB on June 26, 2003, 07:25:12 PM

Where did you get the by-pass card for the FMV ?

JohnB