Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: on February 13, 2006, 12:17:42 AM

Title: Monitor position problem
Post by: on February 13, 2006, 12:17:42 AM

Hi peeps, I have a Piccasso IV in an A4000. Now when I use an app from workbench that uses a native resolution like 640x256 the application is nice and central (cos the monitor remembers how I set it. However, if I need to run an app from reboot (ie a demo) they always move to the right and so need centralising. As far as the monitor is concerned the scan rate and resolution is the same (due to the Piv). What can I change on my workbench to move the apps further left?

Any help would be appriciated.

Regards, Bubble.

Title: Re: Monitor position problem
Post by: InTheSand on February 13, 2006, 12:30:55 AM

Hi,

Have you tried the "Overscan" tool, to be found in the "Prefs" directory on the partition that Workbench is installed on?

 - Ali

Title: Re: Monitor position problem
Post by: on February 13, 2006, 12:32:12 AM

Didn't think of that. I shall give it a try. Ta, Ali :)

Title: Re: Monitor position problem
Post by: on February 13, 2006, 12:38:18 AM

Damn Ali, you are cool. I had completely forgotten about the Overscan prefs. It worked a real treat.

Big thanks dood :)

Title: Re: Monitor position problem
Post by: InTheSand on February 13, 2006, 12:54:29 AM

Cool! No probs...

 - Ali