Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Zero on October 12, 2005, 05:58:20 PM

Title: Electrohome ECM1310 Multisync Help!
Post by: Zero on October 12, 2005, 05:58:20 PM
I have just got hold of an Electrohome ECM1310 Multisync monitor, it works fine and gives a good display dispite it's age, made in 1986!

I am using it on my 4000/40 (spec in my sig).
It's to replace my 1084S.

I want to know whats the best mode to run it in.
I currently running it in DBLPAL High Res No Flicker, and this seems to be the best mode, as a lot of the other screen modes are almost impossable to center, even with overscan.

Any help would be great!
Title: Re: Electrohome ECM1310 Multisync Help!
Post by: Zero on October 12, 2005, 09:13:58 PM
... MULTISCAN:Productivity seems quite good as well.

Also do I need the VGA Driver in Devs/Monitors

Thanks in advance  :-)
Title: Re: Electrohome ECM1311 Multisync Help!
Post by: Zero on October 13, 2005, 09:30:01 AM
Whoops! it's an Electrohome ECM1311 Multisync Monitor.
Still need advice if any is going!  :-D
Title: Re: Electrohome ECM1311 Multisync Help!
Post by: Zero on October 14, 2005, 04:34:31 PM
 :bump:

Anyone?

 :-)
Title: Re: Electrohome ECM1311 Multisync Help!
Post by: Boot_WB on October 14, 2005, 04:57:27 PM
Doesn't seem to be too much info about it on the web:

from http://www.kalibrering.no/instlist.htm

Electrohome Ltd. - ECM1311 - Monitor, Farge, TTL og RGB input, 15 til 32 kHz hor.scan. - MON - ELEC

www.aminet.net

Try MONspecsMUI from aminet, but READ THE INSTRUCTIONS BEFORE USE, and if in doubt, DON'T MESS WITH IT - as it can blow your monitor up if you are not careful.

Should be able to get those hi-res modes centred by adjusting the syncstart/stop and blankstart/stop values, but BE CAREFUL - you don't want to blow your new multisync up.

Good luck
Title: Re: Electrohome ECM1311 Multisync Help!
Post by: Zero on October 14, 2005, 05:06:23 PM
@Boot_WB

Thanks dude, I will have a look and I will be careful.

 :-)