Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: turbonut on September 25, 2005, 06:03:44 PM
-
Installed a Picasso IV into a desktop a4000, with a cyberstorm mk1 060, and tandem ide card installed. I'm now at my wits end trying to get it to work. The drivers will install fine (v 1.27), but upon a reboot I get nothing displayed, I have check via (assigning sys, and env to ram) that the only monitor driver present are PAL and the Picasso driver. This has been done with fresh installs of both 3.1 and 3.9. Any ideas?
-
Perhaps you haven't made the "attach settings" from PicassoMode or whatever it was called - your software is dead old, this is much newer: http://main.aminet.net/gfx/board/Picasso96.lha
2.1 can be found somewhere, too.