Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Zazza on February 18, 2005, 08:16:51 PM
-
Hi everyone...
Could someone suggest or give an advice about these controllers for Amiga 2000:
Oktagon 2008
GVP Series II
GVP Impact rev2
Thank you very much,
Andrea
-
I have never used the Octogon controller, but I have used GVP. The GVP stuff is good, but get the newest versions you can.
It is generally best to have your accelerator work as your first SCSI interface too. It speeds things up. If your accelerator does not have SCSI, and you can't find or afford such a card, any of these should work - The GVP will most likely work with more hardware and software however.
-
In an Amiga 2000 there is actually not much wrong with a Commodore A2091 card. And ofcourse highly compatible!
-
On the 2091, make sure to get at least 7.0 firmware. Older ROMS can't handle drives over 1GB.
-
The Oktagon 2008 uses very expensive and hard to find ZIP package ram. The GVP HC+8 uses very easy to find/cheap 30pin standard simms.
Oktagon = 8mb max onboard
GVP HC+8 = 8mb max onboard
A2091 = 2mb max onboard
If you find an available GVP series 2 HC+8 controller, any rom revision above 4.4 will allow 2gig scsi harddrives and cd-rom without hassles ( this is my experience anyway )
Az
-
JimS wrote:
On the 2091, make sure to get at least 7.0 firmware. Older ROMS can't handle drives over 1GB.
I read that before, but never had problems. Used 2 and 4GB drives on an A2091 (rev 6.6) and 2 A590's (Rev 6.6 and Rev 6.0).
Why would they not work? HDToolbox does see them as wrong size, GVP Expertprep works fine?