Supress Roadshow log output

[outlawal2]

I just purchased Roadshow recently to use it with my plipbox.
I am still trying to get it to work, but there are some logging functions in the configuration that I will bet is causing your issue.

I am at work right now so I can't get the exact info now but when I get home I will look at my config and see if I can find your culprit for you..

[outlawal2]

And I was able to redownload Roadshow and found the info I was talking about.
Your network configuration has a few options for logging and they may be turned on with your install.

Launch SHELL and type the following:
Ed DEVS:NetInterfaces/ENTER THE NAME OF YOUR NETWORK DEVICE HERE  IE Ariadne

Toward the bottom of the file you should see the following: See Below: (Note that all of these options are commented out on my config file.  If you see these lines without the leading # then these may be the culprit.  Simply comment them out and resave your file and try again.

# For diagnostic and monitoring purposes it can be helpful to
# capture network traffic that flows through this interface.
# To enable this option, select one of filter=local,
# filter=ipandarp or filter=everything
#filter=local
#filter=ipandarp
#filter=everything

[outlawal2]

Why is there no option to edit my existing post?

Anyway, there is also a command in this file called DEBUG..  Turn that off as well..