Author Topic: fusion forty problems (Read 6423 times)

TjLaZer · « **on:** March 25, 2008, 05:10:35 PM »

I have one and it indeed does autoconfig the memory. I have 32mb on mine. Make sure you have the correct 68040.library for it. I would also clean all contacts and reseat the PNG Roms.

TjLaZer · « **Reply #1 on:** March 26, 2008, 02:24:46 AM »

I believe that is the stock clock rate 28Mhz. Yes that is correct, overclocked at the factory.

Enter the early RCS Boot menu by pressing the left mouse button on reboot and see if FastKick is enabled.

TjLaZer · « **Reply #2 on:** March 26, 2008, 02:47:52 AM »

Just checked mine and it has a 56MHz oscillator.

TjLaZer · « **Reply #3 on:** March 26, 2008, 05:51:08 AM »

For fast mem to get autoconfigured you have to enable FastKick.

TjLaZer · « **Reply #4 on:** March 26, 2008, 06:40:47 PM »

I've seen them go for about $100. I got mine for $80 with no Ram. 4mb 30-pin simms are hard to find. But not impossible.

TjLaZer · « **Reply #5 on:** May 02, 2008, 04:26:00 AM »

For FastKick to work with 3.1 you need the latest version 3.4 ROMs.

TjLaZer · « **Reply #6 on:** May 15, 2008, 06:23:57 PM »

Sadly I don't have any ZII RTG Cards I can test in mine...

Do you have any 16-bit RAM in your 2000 at all? (NOT the RAM on the F40 as this is 32-bit) If you have more than 4MB in the 16-bit range you cannot use a RTG card (as it has 4MB) Remember 8MB max on ZII bus.

Author Topic: fusion forty problems (Read 6423 times)

TjLaZer

Re: fusion forty problems

TjLaZer

Re: fusion forty problems

TjLaZer

Re: fusion forty problems

TjLaZer

Re: fusion forty problems

TjLaZer

Re: fusion forty problems

TjLaZer

Re: fusion forty problems

TjLaZer

Re: fusion forty problems