Intuition.library v45 not installing for me.

[MikeA3000]

I am trying to copy the v45 intuition.libary from the 3.1.4 modules disk on my A3000 and it doesn't appear to install at least version command does not show it to be updated.
I have gone as far as backup the original intuition.library, delete it and then copy over version 45 and it still shows I have version 40

What am I doing wrong?

[MikeA3000]

I have the renamed intuition.library in libs, I had modified my startup-sequence but my amiga just does a continuous reboot, thats why I was thinking maybe I had the wrong version.
attached is a copy of my startup-sequence. Ignore the .intuit extension. I added that because this version of my startup-sequence will not allow the machine to boot.
I had to restore my previous startup-sequence to get the machine to boot.
I am using version 2.2 Picasso96 driver.
Is there something wrong with the startup-sequence?

[MikeA3000]

Its an Amiga 3000, stock other than the Cybervison64 graphics card. Chip and Fast are maxed out. NTSC version
I installed the SCSI2SD card with a 4GB card.

[MikeA3000]

I am using MMULIBS

[MikeA3000]

Both HEADERFORWARD and ALLTOCHIP works. I left my startup-sequence using HEADERFORWARD.
Before using those options it would boot once with just LoadModule, but if I rebooted it would continuously reboot.
I would have to pull the power and hold down the power button to drain ram and then it would boot again.

I am now getting the correct version of intuition.library and am able to drag windows off the screen.
Thanks Thomas!!
So what are these options doing differently to fix my issue?