CyberstormPPC 68060/PPC 604e

[my_pc_is_amiga]

The Commodore A4kT was supplied with an AT type power supply and that has thin bendy "tongues" inside the power plug that press onto the power pins poking out the A4kT's mainboard. My machine would burn through it's tongues in the connector plug usually about once a year.

I've experienced this too -- at least 2 times.   I was amazed that things worked still after replacing the power supply and after I got a "new" connector soldered on the motherboard. 

[kolla]

Well, my A3000 with CSPPC/CVPPC (and CV64, and a few other cards) worked fine. The only real issue was when the fan of the 604e clogged because of dust at one point, which caused heat and shortcutting of the entire power line on the motherboard, burning the power socket of the mobo. Luckily, I had another spare A3000. The broken A3000 is ready for a "ReAmiga 3000" treatment

[Sugo77]

Hello all!
Someone know how to run glsoukoban in emulator winuae in AmigaOS 4.1 Final Edition?
I have warp3d and wazp3D installed, but get "killer"(error)...

I no idea how correct instlling CyberGraphX in AmigaOS 4.1 FE in emulator winuae, no lessons in full internet...

[kolla]

I no idea how correct instlling CyberGraphX in AmigaOS 4.1 FE

You don't. OS 4 comes with its own RTG solution, you cannot just replace it with CyberGraphX.
(CyberGraphX version 4 and below is for AmigaOS 3, 68k systems, versions above are integrated in MorphOS on PowerPC)

However, the OS4 RTG has a CyberGraphX compatibility layer and any software written for CyberGraphX v3 (at least) should also work on OS4. How all the 3D stuff plays into this, I have no idea.

[Boing-ball]

Worth a shout over on the Hyperion Forums. I have Amiga OS 4.1FE, but not really played much with it……