How To Install WB 3.1 from Gotek

[Oldsmobile_Mike]

Just to confirm: if you completely remove the P96 software using the process you described earlier, and change back to a native screenmode, you still get the error message on boot?

At what point did you first see this message?

[kolla]

A typical thing to do would be to start without startup-sequence and use "set echo on" and "execute s:startup-sequence", and see at what point in startup-sequence the error is triggered.

[pneron]

Ok, uploading key files...will try what was suggested as well with "echo" on startup

[pneron]

Just to confirm: if you completely remove the P96 software using the process you described earlier, and change back to a native screenmode, you still get the error message on boot?

At what point did you first see this message?

Good point ! will check to see if this message still comes-up after removal

[pneron]

After a complete UNINSTALL...I still get the PicassoIV message?

[Oldsmobile_Mike]

Did you try Kolla's suggestion?

[pneron]

not yet, but will try his suggestion. Thanks

[gertsy]

Did you try Kolla's suggestion?

Kudos Oldsmobile_Mike, this is like the old AOrg days. Helping fellows v espousing pseudo intellect.