I ordered and received my buddah from amigakit about 2 months ago. It boots fine with the DOM module and goes to the install screen. However, Any device i hook up the other other main ide port (yes with a 40 wire ide cable and the jumpers removed and DOM removed) puts my amiga in a non bootable state. Even though the wiki states the card works OOTB. I was hoping to use the 40gb ide drive from my old A4000 with all my files on it. Its set to master and just locks the machine... I also tried another older ide drive i had sitting around and same thing. Any advice? I forgot to order the cable for the jtag but the board should be loaded with the most recent firmware from amigakit right?