« on: March 26, 2021, 11:21:33 PM »
I'd bet a pot of gold on the secondary sensor being a thermistor on one end of the cable and a compatible plug at the other.
Widely available already from 3d printer stores, the only issue is getting the right sensor (they all have different resistance curves).
With a thermometer and a kettle of boiling water, you could work out what the offset was even if you fitted the wrong sensor.
« Last Edit: March 26, 2021, 11:24:45 PM by Pat the Cat »
Logged
"To recurse is human. To iterate, divine."
A1200, Vanilla, Surf Squirrel, SD Card, KS 3.0/3.z, PCMCIA dev
A500, Vanilla, A570, Rev 5, KS 1.2/1.3 Testbench system
Rasp Pi, UAE4ARM, 3D laser scanner, experimental, hoping for AmigaOS4Arm, based on Watterott Fabscan Pi
