my cd drive not working again?

[klx300r]

Was working with 3.14 and stopped when 3.2 came out so had to use AtapiMagic from aminet as per OS3.2 FAQ and was working fine again. Now with OS3.2.2 I don't see my cd's yet again?


-made sure to copy over the lines needed in the S-S from 3.2.1
-didn't change anything else with any cables, settings etc.
-Showconfi showing CD drive as unit 2
- get no error messages at boot & when CD is inserted LED lights up like normal but nothing shows up on workench? If I go to DOpus and type cd2 it tells me 'no disk present in device cd2:'

[AndyFC]

I upgraded to 3.2.2 this morning and had no issues with my CD, so this isn't a universal bug.

What cd device do you have in sys:Devs/dosdrivers/? Just because the cd is unit 2, doesn't mean it's mounted as CD2:

When you say you copied over the lines in your startup-sequence, do you mean the loadmodule section for atapimagic?

[klx300r]

using same device as before nothing has changed. I have tried changing to all unit numbers and nothing?


yes for AtapiMagic but i’m thinking perhaps I placed the lines for AtapiMagic in the wrong place? I’ll send over the S-S lines affected later when I’m in front of my Amiga

[utri007]

If nothing has changed, then it is hardware issue. Usual suspect would be PSU.

[klx300r]

PSU working and tested fine this is a driver/ settings issue