So after my misfortune with a Cybervision 64 card starting to play me up, I pulled out a ZZ9000 card I had in storage to try instead. On installing and booting up I can get a picture showing the Kickstart screen etc…
No this is where the issues arise. On early start up ( 2 mouse buttons) and looking at the Board Diagnostics. There is no ZZ9000 board showing. So guessing here it doesn’t use Auto config. But when I add cards like a X-surf100 or a Gofaster RAM card with the ZZ9000 they do not work. Again Board Diagnostics does not show these cards.
I have downloaded the latest Firmware from the mnt website (V1.13 for Z3) and have copied it into the 128MB SD card. But still no dice.
Anyone any ideas on this?