Amiga.org
Operating System Specific Discussions => Amiga OS => Topic started by: jaesonk on July 28, 2023, 06:25:45 AM
-
My A4000 with OS 3.2.2.1 was working fine. Now it won't boot. I'm getting to LoadModule failures:
LoadModule failed: object not found
LoadModule failed: returncode 10
I don't know what's wrong. What might be causing this?
-
Check the first section of S:Startup-Sequence. There are various LoadModule lines which list several modules explicitly.
When I looked there were these:
L:System-Startup
L:Ram-Handler
L:Shell-Seg
Libs:dos.library
Libs:gadtools.library
Libs:graphics.library
Libs:intuition.library
Make sure that they all exist.
-
I took a look at the startup-sequence with some fresh eyes today and check the modules and libraries. All of them were present, however something truncated the first LONG LoadModule line in the Startup-Sequence. At the very end, it just said "graphic". I assumed it was supposed to be "graphics.library", fixed it and rebooted successfully/normally, mostly.
A secondary problem has been an issue since installing one drive. On a cold boot, it goes partway then stops, it fails to reboot on its own, a warm boot after that will take me all the way to Workbench. Here, LoadModule Failed reports: Some devices are validating, reboot aborted.
I can keep doing the manual reboot after a cold start, but can LoadModule be told to wait a little longer?
Thanks.