Small resistance between 5V and GND normal?

[efrenmgp]

Hello!

I am working on an A500 6A motherboard but I noticed something that I don't know if it is normal or not.

Whenever i test for continuity between 5V and GND, I assume the should be none, ever. But what I get is a very brief beep (about a second or so) from my multimeter and then silence. Then I tried to measure resistence and I get something around 60 Ohms between 5V and GND. However the machine works (turns on, reads floppies, makes sound, has video output, reads the mouse...) The only thing that does not work at all is the trapdoor expansion. I put a 512 KB expansion with clock that I know works fine and neither the ram nor the clock are visible to the Amiga. Other that that all appears to be OK.

Are those readings something normal? If not... any advice what to look for?

Thanks!
- Efrén

[efrenmgp]

Hello!

Thank you for your answer I tried and yes, that's exactly what happens if I invert and test again, and again, and again... I can spend all day hearing those short beeps hehe

About the cap... there are many caps that sit between 5V and GND, decoupling caps I think they are, so ok, If that's expected then I'll need to continue searching somewhere else for the trapdoor issue.

This machine had an A501 whose battery went mad and the acid affected even the motherboard, so I think chances are high some trace or component got damaged, hopefully I'll find the problem soon.

Thanks again!

- Efrén

[efrenmgp]

Well I found the problem and turns out it was a mechanical issue with the connector itself making a poor connection. By just slightly pulling out the memory expansion, like 1 mm or so, it is now recognized. Both RAM and clock. I have tested 3 expansions and they all work when I do that, and they don't if I push the expansion all the way in.

Thanks again gizmo350!