I've installed mine in my A4000. It detects the inserted CF Card by when I try and use HD Tool box to set it up then it hangs after the detection. It is probably the SCSI jumper settings on my Warp Engine 68040 card as another card which is already formatted and set up with OS3.9 causes the whole system to guru when inserted.
I shall continue to experiment.
Could someone offer some advice here?
The SCSI card reader when attached to the Warp Engine in my A4000 reported the device as Unit 2 and a CF card directly inserted into the CF socket as being at Lun 2. However, HDToolbox after detecting it would then hang the software. Find Device would also report the card as being in Unit 2 at Lun 2. I tried every combination of jumpers for the SCSI adapter on the Warp Engine and nothing allowed me to access the card to format it (always hanging after detecting it on Unit 2 Lun 2). Using a CF adapter on my FastATA4000 I formatted the card, but the SCSI card reader still wouldn't mount it.
I then attached it to the SCSI adapter on my A2000's GVP G-Force 040 card... and it detected it at Unit 2 Lun 1 and promptly partitioned it, formatted it and mounted it on reboot.
Anyone got any ideas what I'm doing wrong with the A4000?
Cheer.
It is worth pointing out that the CF card on the SCSI card reader out-performs the SCSI hard drive on the same adapter and the CF Card mounted in an adapter attached to the Buddha:
IDE (Buddha) CF Card: 1,414,446 bytes/sec
SCSI Hard Drive: 1,601,694 bytes/sec
SCSI CF Card: 1,876,926 byes/sec
All using FFS.