Hi all!
After drooling for decades as a young adventurer over any amiga I could find in the neighbourhood I finally bought a trusty amiga 500 rev 6 with 1mb ram.
My happiness and excitement are to the sky, finally!
I was busy restoring the poor fella and modding a bit and I put a gotek and a switchless mod.
There started my problems...
The gotek works perfect if I use it as df0 on internal connector but not on the external one (switch df1 to df0 with switchless mod).
Same destiny for the working internal floppy: dead on the external port.
I head it spinning but then I see the icon of the floppy on the screen asking to insert it.
With the normal amiga floppy connected on external port and gotek on internal I started the amiga test kit and there it shows no df1 connected.
Then, absurd, when I do "signal test" BOTH drives spin?
Is this normal?
If I select specifically DF1 and do signal test the drive spins but I get "DF1: No track 0 (Drive not present?)
What can I try to further troubleshoot?
I inverted CIAs, same behavior.
Thanks for your time and patience.