I'm now (finally) running OS 3.9 on my 2000 thanks to the help I've gotten here, so now I wanted to get my DKB 2632 activated. It is maxed out with 112 MB of RAM and used to work fine with OS 3.2. But now I find that when I give the "2632" command, I get a pop-up error "FS3 has a read error on disk block 10nnnnn" (the last five digits vary). FS3 is my SCSI2SD boot drive. But even worse is that once I dismiss that message, I can't run any other DOS commands - dir, list, avail, time, etc. all bring up the same pop-up. All I can do is a cold reboot - a warm boot just produces the animated "insert a floppy disk" screen. I don't get any disk errors on any commands before giving the "2632" command.
Other difference: before I was using an A2091 SCSI controller and now I have a GVP 2000 HC+8 with 4 MB of RAM on it.
FWIW, this is what I get before giving the 2632 command:
> avail
Type Available In-Use Maximum Largest
chip 1706368 374400 2080768 1584424
fast 4973696 3414912 8388608 4968368
total 6680064 3789312 10469376 4968368
Then when I say
> 2632 -d
2632 Resident Module
Getting banksize
Banksize= 02000000
Priority= 5
Base = 04000000 Size = 04000000
Base = 01000000 Size = 01000000
2632 ResMod: Size 01BC, From 005229F0, To 00036770, Offset FFB13D80
2632 Resident Module relocation complete
2632 Resident Module Added
2632 memory configured
As a test, I booted from a 3.1 floppy and gave the 2632 command there. It worked fine, avail reports the extra 112M of RAM, and all the DOS commands still work.
Is there some trick to getting the 2632 working in OS 3.9? (Or is this even possible).