« on: September 18, 2021, 07:39:54 PM »
I got a floppy power cable from AmigaKit to connect my SCSI2SD v. 5.2 directly to my GVP HC+8 controller card. Unfortunately, the connectors on the cable were keyed and didn't fit on either the SCSI2SD or the GVP so I had to cut off the keys. Now I have two connectors that can go on either way.
GVP was nice enough to print on the board which pin was 5 v. and which was 12 but the SCSI2SD is unlabeled. So could someone please tell me which end on the SCSI2SD is 5 v.? The one nearest the SCSI cable or the one nearest the edge of the board? I've looked everywhere and can't find this.
Going by the connector I'm currently using (one of the pigtails from the Amiga's power supply whose key does fit only one way), I'm guessing that 5 V. is the end nearest the SCSI connector since that wire is red and red should be 5 v. But I'd appreciate confirmation before I let the magic smoke out of my SCSI2SD.
Logged
Active: B2000 4.4, A2630, GVP 2000 HC+8, DKB 2632, SCSI2SD, Gotek, Deneb USB, XSurf 3cc, CD ROM, Megachip 2000, ECS Agnus, Denise, OS 3.9, GVP Spectrum EGS 28/24, Silicon Springs GOMF
Retired: A2088, 8-Up, A2090a, Oktagon 2008, Kitchen Sync
Busted: A2091