« on: May 06, 2021, 06:00:22 PM »
It cost GVP a lot to setup the injection moulding for those cases.
I understand they had about 4 million in investor funding. Quite an advantage at the time
Anyway, nice job. I'd have gone for about 110 myself. Just to make sure.
EDIT: And because my work area is chilly.
« Last Edit: May 07, 2021, 12:37:16 AM by Pat the Cat »
Logged
"To recurse is human. To iterate, divine."
A1200, Vanilla, Surf Squirrel, SD Card, KS 3.0/3.z, PCMCIA dev
A500, Vanilla, A570, Rev 5, KS 1.2/1.3 Testbench system
Rasp Pi, UAE4ARM, 3D laser scanner, experimental, hoping for AmigaOS4Arm, based on Watterott Fabscan Pi
