Welcome, Guest. Please login or register.

Author Topic: Amiga Odds - Ends For Sale  (Read 762 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline RodomocTopic starter

  • Jr. Member
  • **
  • Join Date: Aug 2009
  • Posts: 97
    • Show only replies by Rodomoc
Amiga Odds - Ends For Sale
« on: August 27, 2009, 10:29:11 PM »
I have a number of Amiga items I need to part with.
 
1) 4 x Amiga 500's. Each with power supply. They all work but I will verify again before I actually send them out.
2) DKB ROM switcher (used in A500, probably works in A2000 as well)
3) 3 x 512K Ram expanders for A500 (all Commodore version)
4) Exterior hard drive module A500. (smaller scsi drive <100MB)
5) Exterior Commodore CDROM module A500 (drive tray jammed)
6) A1000, power supply, Original floppy disk set (includiing kickstart disk)
7) Commodore RF modulator
8) Commodore 1950 monitor (works fine) This has VGA plug.
9) MegaChip for A500 and I think A2000. Allows for newer Agnus.
10) Accelerator for A500. External. (will have to check speed but it is still just a 68000, just a few mhz faster than original) Is pass through thus allowing side expansion devices (such as hard drive module listed above)
11) GVP TBC+ card (time based corrector) with Digital Comb Module. No breakout cables though, sorry :(.
 
So that is the stuff that for sure needs to go. Just PM me if you are interested in any of it or have questions.
 
I do have a fairly complete A3000 system that I will take offers on. This is a complete running system that I still use.
 
-Rev 7.x board.
-3.1 ROMS (note this is the motherboard with ROM adapter)
-16MB
-25Mhz version
-Buster 7 (I cant remember other chip revisions but I can say that all chips from a Rev9 motherboard went into this one)
-Zorro daughtercard from Rev 9 motherboard.
-A3640 accelerator (version 3.1 from Amiga Technologies; best version) 68040-25mhz.
-GVP Spectrum 24/28 RTG Video w/ 2mb ram
-Elbox Fast ATA controller Card has 2 headers for a total of 4 devices.
-X-Surf ethernet card (2008 version)
-Subway USB (from X-surf clockport). USB2 x 4 ports (not high speed)
-One clockport still available on X-Surf
-Amtrade 1.76MB floppy drive
-Still have 1 zorro slot open
-External self powered drive box (Compaq). (2) 5.25" bays. Newer CDRW drive (2008). Have round IDE cable running from A3000 to this box.
-4gb scsi hard drive (I never did get around to hooking up ide drive to Fast ATA card. This would be more ideal.)
-All software install disks for various hardware upgrade items.
-original keyboard.
-original mouse (I never use because USB roller wheel mouse better!)
-cosmetically this computer is in very good condition. No yellowing of front bezel, etc... It is still pretty after all these years.
 
-Currently runs OS3.9 but I would like to keep this so I would include
Workbench3.1 instead. I'll even reinstall this OS and configure all hardware so new owner gets a machine that boots up and runs. (you are on your own regarding TCIP setup though, included will be X-Surf software that seems to have automated scripts for installing a couple of TCIP packages)One can easily install 3.9 over top of 3.1 and not have to reconfigure all hardware again (quite a process believe it or not)
 
Again, send me a PM if you are interested.
 
Thank you.
 

Offline tone007

Re: Amiga Odds - Ends For Sale
« Reply #1 on: August 27, 2009, 10:51:08 PM »
A couple heavy items there, where are you located?
3 Commodore file cabinets, 2 Commodore USB turntables, 1 AmigaWorld beer mug
Alienware M14x i7 laptop running AmigaForever
 

Offline RodomocTopic starter

  • Jr. Member
  • **
  • Join Date: Aug 2009
  • Posts: 97
    • Show only replies by Rodomoc
Re: Amiga Odds - Ends For Sale
« Reply #2 on: August 27, 2009, 11:20:24 PM »
Location = Wisconsin, USA.