|
Scandoubler bracket mod (inside) | ||
Previous Image | Next Image | ||
Description: This is the bracket mod as it looks on the inside. It is a bit ugly due to the hot glue but I did\'nt want to hack my case to pieces by drilling holes through it. I sanded the plastic a little and hot glued all. It became very strong. Would the VGA connector support it you could hang an elephant on this :-o ( little exaggerated )
Picture Stats: Views: 3010 Filesize: 132.46kB Height: 768 Width: 1024 Posted by: Doppie1200 at September 11, 2004, 08:40:03 AM Image Linking Codes
|
||
0 Members and 1 Guest are viewing this picture. |
darksun9210 Posts:1317 | October 17, 2008, 12:40:42 PM one of my 1200's has the scsi port from a BPPC there, and a subway card, and a USB port to the side. but i've taken out the USB port to fit the VGA out from the blizzard card.. i have two other usb port where if you can imagine the mouse and joystick ports were on the A600... there is alot of room under that floppy drive ;-) |
rkauer Posts:3263 | October 10, 2007, 04:43:21 AM SCSI controllers... |
Spectrum75 Posts:40 | June 09, 2006, 10:17:51 AM Nice mod! BTW, What was this space in the case originally intended for ? |
Xanxi Posts:897 | April 15, 2006, 12:20:36 PM Are you sure this glue is not inflamable? It would be a pity that heat causes the whole computer to burn because of the glue. |
koaftder Posts:2116 | February 01, 2006, 10:24:23 AM Cool, nothing like a good hack. It's not going to stand up to abuse though. If you are careful, i'l will last a long time. Ive got a drill, i would have drilled a hole in the front and side of the bracket and plactic, and used a bolt and a little screw just to make sure it held up under a small ammount of stress. |
Vincent Posts:3895 | September 11, 2004, 04:11:57 PM That's a nice mod there :-D Quote Would the VGA connector support it you could hang an elephant on this :-o ( little exaggerated ) :lol: |