I've got an idea im working on with regards to the floppy LED (Since this is the least used of the three...).
I'd like to maintain the exact same colour scheme as the A1200 in terms of LED's and avoid adding additional LED's all over the place, so what im going to do is replace the dual-LED floppy indicator with a pair of rectangular yellow LED's, fill the gap between them with some special white plastic spacers which I should have made tomorrow, cut a track on the underside of the LED board, reroute ground a little, tweak the existing FDD led resistor, and get it so that the right most yellow LED (Which im going to have to add a extra wire for) will indicate PCMCIA access - And the left most LED will still indicate FDD activity.
I thought about adding a dual colour LED, but the problem is i’ve never seen them in rectangular LED packages, and getting the light output from a standard round LED to illuminate the slot properly is virtually impossible.
I’m still undecided whether to attempt to find and solder some SMD parts to the motherboard (The resistors should be easy enough to find as SMD, the 2N3904 will probably have to be discrete though...); or bring two wires off from either end of the pads for R637 to a little veroboard board with the discrete parts mounted on it.
Hodgkinson.