Matzes a1k.org Graphics Adapter...

[Rotzloeffel]

Hey Thomas, thanks for the insight! I never would have guessed that you drag that button into those fields! Gotta read the guide! Anyhoo, I checked to see if there were any P96 screenmodes in ScreenMode prefs again and there were some!

Instead of adding or edititing screenmodes you can use these Picasso96setting File.... extract it to DEVS:

The only thing to do ist to attach your Board.....in p96Mode

it contains any known VESA Standard Resolution and work perfekt with this Board

have fun.... nice card

[giZmo350]

@Rotzloeffel

O-M-G!!!! Thanks sooooo much!

I can't wait to get outta work and use this!!!!

giZmo

[Rotzloeffel]

@Rotzloeffel

O-M-G!!!! Thanks sooooo much!

I can't wait to get outta work and use this!!!!

giZmo

Your welcome my friend.... let us know, how it works for you

[3246251196]

Not sure why, but I always need to restart my machine for this to work. Granted this is in a sort of non-standard setup: A500 with aca 500 ++ (the checkmate case came with the zorro 2 board) so I bought this card. It is great, but trying to figure out why I need to restart.

Initially I will get a message that pops up very, very quickly. I am not sure how to log that or find the command that is being run to pipe the output to a file. I caught the message:
"check your picasso96 installation" etc /etc "Assuming GBAPI..."

When WB loads I don't see the board in Picasso96 and I cannot select any modes in the ScreenModes tool. But, restart, and it works fine.

- Installed picasso96 from Aminet,
- Installed the GBAPI drivers
- Changed the tooltype info of the Picollo 64 monitor BOARDTYPE=GBAPI++