A big thank for this little nugget of advice, you've saved me a morning of stress! Go out and buy yourself a sweetie! (I recommend curly whirly or a toffee crisp) 

The A600 is finally booting! Since the last LAG meeting, I've been trying to get 3.2 installed, then finally gave up as it just would not install properly. I later read that the Furia cards have issues with WB 3.2 and I might need to firmware update the card ugh I'm not going to say just how many days I wasted trying to get it working (too many).
 
I decided to go back to an OS I used to use regularly on my A3000, 3.9. While I do have a squirrel scsi, I'll be buggered if I know where it's gone, probably scurried off collecting nuts or old AF cover disks lol So I thought, why not use WinUAE? I learned the hard way not to setup a hard drive using an emulator, after I spent an evening setting up a CF card, installing 3.1, only to insert it in the Amiga and it report that it couldn't find "HDUAE.device". So last weekend, I set the drive up on a REAL Amiga and then did all the software install, tweaking etc in WinUAE. I thought I was being pretty slick, as it was all going off without a single issue. Until this morning when I installed the CF back in the A600 and it essentially gave me the two fingers 

Again thank you! I'm planning on writing about this on the club website, certainly going to make a mention about Furia cards and rom patches.

Reduced intensity of Captcha, is that better.

Not sure why your being asked for it when sending PM. There is no option for this.