Hi guys,
I have decided to design a housing for the FPGAArcade Replay.
Some of you maybe remember I did a few runs of minimig housings.
There will be two kit versions of cases including spacers and bolts.
The cases will be made from Plexiglas just like the minimig cases.
Versions:
1. For the FPGAArcade Replay mainboard.
2. One for the FPGAArcade Replay Including the 060 daughterboard.
This version will include a sunroof/hole for the processor so the heat sink can vent out the top op the case (only the square heat sink will be supported)
********* ********** UPDATE ********* **********
The first prototype for the FPGAARCADE is ready ;-))
This is the version for use with the FPGAARCADE mainboard only (so the mainboard without the daughterboard from Yacube)
There are two set options:
Set 1 AMI: Amiga Set Complete set including spacers and bolds Including Amiga Text and boingball logo (see picture nr.1).
Set 2 UNI: Universal set NONE logo's Complete set including spacers and bolds (see picture nr.2)
I can supply more logo's in the future but we will see.
If you are interested in one of this sets let me know I will keep a list of peoples interested.
The minimal units I have to get is 25 before the production can take place.
If The 25 units are confirmed I will e-mail ALL for payment then the production will start (I WILL DELIVER as I did in the past just look up the minimig cases thread)
Cost:
Set UNI Universal set E 28,50 shipment E 12,00
Set AMI Amiga Set E 36,00 shipment E 12,00
The case design including Yacube’s daughterboard is not begun yet because I don’t have any measurements.
I will contact MikeJ or Yaqube if there is progress in rerouting the daughterboard for the CPU placement on the new daughterboard.
***** Update 16-5-2011 *****
Okey boys and girls,
After some e-mail swapping between MikeJ and me there are some changes here.
MikeJ has ask me if I want to use his original fpgaarcade logo on the case's (let me think ;-) YEEEEEEEEEEEES !!!! )
So here is a update from the case on drawing, the quality of the product will be the same as the pictures on page one, so only the engraving will change.
The picture is for the amiga version the Universal version is the same like this without the amiga logo, DUhu..
The 060 daughterboard version will also include this logo and some other stuff ;-) Daughterboard version pending….
*** LIST of peoples who want a Set***
1. 1 x Set AMI Maffoo @ Amiga.org
2. 1 x Set AMI Darrin @ Amiga.org
3. 1 x Set AMI gxenakis @ Minimig.net
4. Set
5. Set
6. Set
7. Set
8. Set
9. Set
10. Set
11. Set
12. Set
13. Set
14. Set
15. Set
16. Set
17. Set
18. Set
19. Set
20. Set
21. Set
22. Set
23. Set
24. Set
25. Set
I Hope you all like this version ;-)
HIRES PICTURES MEGAUPLOAD, PM me if the link is dead
http://www.megaupload.com/?d=ZOAKCUQ3
