Amiga 2000 install A2088XT and Seagate RLL ST-11 installation, plz help me!

[qwalo]

hello,
i want to install an untested hard disk and an untested pc emulator A2088XT.

Given:
- Amiga 2000 working well
- Kickstarter 1.2
- Drawbridge (pc to amiga floppy disk)
- Floppy disks
- different versions of Workbench
- Janus installation floppy disks

I boot workbench 1.3 and deleted the most not necessary tools from workbench.
if i install janus the installer told me there is not enough space on the workbench disk.
if i remove all tools, the installation disk can not boot fastmem missing.

=> How can i install janus and get rid of the no space left error?
==> I check the manual, but there is only the hint to remove not necessary tools, i remove most tools, but that was not enough.
=> How can i install the old RLL harddrive from seagate?
=> How can i test both hardware?

==> I think all jumpers were set okay, because the hardware was inserted in the amiga.

[qwalo]

Hi,
sorry for the confusing message.

The Seagate hard disk is connected through an Seagate ST11R ISA controller.
i have no driver disk found.

i don not know howto to install the hard disk.

greetings

[qwalo]

hi,
thanks for the reply.
in the first step i want to test the drive and emulator card.
i can burn roms, i ve several programmer.
is kickstarter > 1.2 recommended?

How can i install the harddrive, i ve found no information.
Can sb help me with the setup.

i dont know if the seagate drive is only for the emulator or the amiga itself.

thanks

[qwalo]

Hi,
sorry for the next question.
i can not test the hard disk with kickstarter 1.2 and workbench 1.3 or 3.1?
Thanks

[qwalo]

Hello,
i am one step further :-)
i try an different janus version (the oldest) and it was installed without any error *happy*

bu now i ve the next problem. if i start the pc mode, the 5,25 drive starts to read.
but i ve no 5,25 janus dos floppy.

=> Where can i get the version, have the floppy an dos or amiga formated?

Thanks, if i get furhter, i will write it.