ACA1233N

[outlawal2]

Good Morning!

Just purchased an ACA1233N for my A1200 and have plugged it in and it appears to be working although it is whining about the 030 libraries.  I will be installing 3.1.4.1 on this machine and am looking for any gotchas or recommendations specific to this setup I should watch for.  Currently it is not recognizing my CF card that is plugged into the IDE controller but again I simply turned it on to see if it would boot and have not investigated this issue further.

Any suggestions or things I should keep in mind with this setup?
 

[outlawal2]

Because I booted to the workbench floppy and when it booted it cries about the libraries...
I haven't moved on to the install yet as I wanted to see if you folks had any suggestions BEFORE I started the installation

[outlawal2]

ROM installed is the 3.1.4 ROM and I had Amiga OS 3.1.4 installed on the CF drive before I installed the new accelerator but as I said I haven't really dug into the CF issue yet.  I am currently at work and will dive in deeper hopefully tonight.  I wasn't sure if maybe the accelerator had to have something set to recognize the IDE controller or something like that. 

[outlawal2]

Thanks Thomas I will look for that and when I start the install I will load it
Thanks to everyone as this is exactly the kind of information I needed and was looking for..