« Reply #4 on: March 05, 2021, 04:30:54 AM »
It looks very good but I'm wary of laser cut clear acrylic. Broken a few bits and bobs made that way. OK I superglued them together but you can always see they was busted.
If you know the technique it wouldn't be that hard to get them cut in polycarbonate. The tricky part is designing a case.
EDIT: And making sure all the dimensions are accurate for every hole and corner cut for each piece.
There are some places that will cut an odd angle on an edge for slanted joins, but most don't offer that. Means sanding done edges for slanting edges. You can't get them perfect but you can get acceptable (with the right equipment like... lots of grades of sandpaper.
« Last Edit: March 05, 2021, 04:58:06 AM by Pat the Cat »
Logged
"To recurse is human. To iterate, divine."
A1200, Vanilla, Surf Squirrel, SD Card, KS 3.0/3.z, PCMCIA dev
A500, Vanilla, A570, Rev 5, KS 1.2/1.3 Testbench system
Rasp Pi, UAE4ARM, 3D laser scanner, experimental, hoping for AmigaOS4Arm, based on Watterott Fabscan Pi