a1200 probs

[pooop]

I am in the process of getting my a1200 tower up and running again but have run into a few issues.
1: have installed a 80gb hdd but is only recognizing 20gb of this i have set up dh0 as a 2.2gb partition and have tried sfs and pfs but still only shows as 18gb partition
2: the graphics card is only working with one resolution 16 bit 640x480 anything else and the lcd tv says it is out of range full specs see below
3: i keep getting a terminate ppc nag requester on boot up and would like to remove it.

any help appreciated

A1200 tower
OS3.9
80gb hdd
blizzard ppc card 160/40
bvision graphics card
128mb fast ram
4xeide interface
cd-rw drive
100mb zip drive

[pooop]

i am using cybergraphx v3 that came with the ppc/bvision cards and i am using a wharfedale 32" tv as the monitor

[pooop]

have got the hhd sorted almost, got a 2.2gb for wb and 68gb for work and now got a ramlib error after a fresh install of os3.9

[pooop]

i am not sure about the lib and not yet but i have bb 3&4 on a zip disk

[pooop]

*update* I have started again from scratch. Hard drive is sorted. Have not installed warpos or 3d as of yet so no nag requester cgx modes have disappeared but the prefs are in devs/monitors, I presume this is down to boing bags altering the startup sequence. Also I  have bought a new rgb/scart from amigakit and just get a white screen when using games. I have another one that works fine with crt but get black and green screen on the lcd tv. Would just like to get a decent resolution and be able to use 1 lcd tv for cgx and ocs, ecs and aga screen modes