Right now with v1.7.2 I can tell WB loaded up as the HD led flashed as normal and I can tell that 'noclick' was activated BUT I can't see anything at all on either the VA2000 screen or Indivision AGA screen
Normally VA2000 should not interfere with the native graphics output. Could you do it step-by-step:
1. Without VA2000 inserted, save a PAL HiRes screenmode (or similar).
2. Delete Libs:Picasso96, Devs:Picasso96Settings, Devs:Monitors/va2000 (or uaegfx or however you called the VA2000 monitor file)
3. Insert VA2000 and boot.
4. Do you see Workbench via Indivision?
5. Run ShowConfig to see if VA2000 is properly recognized (vendor id 28014).
6. Only then install Picasso96 freshly, selecting only "uaegfx" driver
6b. Change BoardType in Devs:Monitors/uaegfx to "mntgfx" and save
7. Copy mntgfx.card from 1.7.2 drivers archive to Libs:Picasso96
8. Copy Picasso96Settings from 1.7.2 drivers archive to Devs:
9. Run Picasso96Mode
10. Can you see the modes? Can you click Test on 1280x720 at HiColor?
If something goes wrong, please tell me at which step.