Minimigs on UK Ebay, and check out the sticker on the mobo!

[hardlink]

Boot_WB wrote:
I've got two front PCMCIA ports on my A4000 which work perfectly with SD/MMC card readers/writers...

How is it that you have PCMCIA ports on an A4000?
I have an IDE-to-CF adapter, but I didn't know you could add PCMCIA ports to an Amiga that didn't already have them

[Boot_WB]

Using a scsi-pcmcia bridge (the MPL McDisk-E).
It provides 2 PCMCIA ports, allowing memory cards, compact flash, etc to be read (using a PCMCIA adapter), and claims to allow access to PCMCIA I/O cards too (although, since no Amiga drivers exist as yet, this is purely theoretical).
Works fine with memory cards though :-)

[hardlink]

Boot_WB wrote:
Using a scsi-pcmcia bridge (the MPL McDisk-E)... Amiga drivers ... Works fine with memory cards though :-)

I have (somewhere) also a pcmcia box with a scsi interface, but I didn't know it would work on an Amiga. And I don't remember the brand. Where did you get the driver?

[AJCopland]

I just got my board from Nusim today when I got home from work, excellent work! It's so pretty I almost DONT want to deface it by building it! :-D

Andy

[Boot_WB]

hardlink wrote:

Boot_WB wrote:
Using a scsi-pcmcia bridge (the MPL McDisk-E)... Amiga drivers ... Works fine with memory cards though :-)

I have (somewhere) also a pcmcia box with a scsi interface, but I didn't know it would work on an Amiga. And I don't remember the brand. Where did you get the driver?

No driver required for this, the memory card is seen as a hard disk under hdtoolbox.
SCSI ID is set using jumpers on the board, and the unit uses standard scsi command set, so no drivers required.