A3000 & Cybervision64 problems

[rrete]

HI!

I'm having problems to install a CV64 (not 3d) in my A3k. With original drivers system crashses, with CGX V 3&4 too. The CV64 is working and in the early startup is listed.
I'm trying install with OS 3.0, 3.1 and 3.9 and I've the same problems. Usually when crash show a guru 80000004 other times the system only stop with no mouse movements and no keyboard respose but "ctrl+A+A" works. My system is an 68030 2mb chip + 16 mb fast and Superbuster 7 or 9
(with two fails)and X-surf I.

Somebody can help me? must I upgrade to SuperBuster 11?

Thanks RRete. :idea:

[Tahoe]

No need to upgrade your buster, I have a Cybervision64 running in my A3000T (and before in a regular 3000) both have rev 7 busters. Mine has always worked fine.
Have never used CGX though, I run Picasso 96, the version which comes with OS3.9.

[Framiga]

i had the CV64 here too with Buster 9 but you have to set a jumper to "Slow Buster Mode". (JP1 IIRC).

[rrete]

Hi another!

Thanks for your solutions. I've trying changing jumper on CV64 & Picasso drivers (they come with OS 3.9) but don't work. I'm trying others solutions. I think the CV64 i'ts working well and is not the problem only software problem.

Best regards from Spain

[Jose]

Hi. Well, to be sure the problem is the A3k (or it's configuration) you can try it on your A4000.

[dnelsonfl]

@rrete,

Not to suggest bad news, but I had a similar problem with a CV64. The guru 80000004 turned out to be bus errors. I tracked it down to read/write attempts in the Cybervision's address. It would crash or freeze the 3000 w/Piccasso 96 or Cybergraphx. I finally got a 4000 and tried it in that with the same results. And this was with superbuster 11 in both 3000 and 4000. Conclusion: the card was faulty. So if you do have a 4000, or even another 3000, give it a go in that Amiga. If you get the same or similar results, it's the card. Sorry.

-David