Well i am running AmigaOS 3.9 and have installed genesis etc I have uploaded a video to show how i am trying to configure it and hope you guys can help here is the link
http://www.youtube.com/watch?v=VQRNV7-n_q4
1. Device and unit are OK.
2. You don't need special configuration, so you should select "No" to that.
3. Unable to open device might be either because of the PCMCIA reset bug on A1200 or you haven't executed the SetPrism2Defaults command with correct options in s:user-startup or from shell before trying to use.
Quick and dirty fix for reset bug for one session would be to hotswap the card (unplug+plug while computer is turned on) and then execute correct SetPrism2Defaults command.
For permanent use check
CardReset and
CardPatch commands in Aminet. And have SetPrism2Defaults in s:user-startup.
4. You have to know your local IP-address and enter it manually in the config.
Basically you must know unique IP-address you're going to use for Amiga (first three numbers same as on your other computers, but last number different than on other computers), netmask (same on all computers on your network), gateway (same on all your computers in your lan, usually the IP-address of the router) and nameserver (usually same on all your computers, might be the address of your router).
So, check your other computers settings to retrieve the needed info, if you don't know it already.
5. If you're unsure of the software issues, you might first try to get your Amiga online with
this. When you get it working, you know everything is OK hardware wise and you can then start thinking what is wrong in your software setup.