Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: AmiJIm on December 04, 2017, 04:11:19 PM
-
Hello there,i am trying to revive my amigas and it is time to check my a1200 with a cybervision 64/3d with a scandoubler in a micronik tower with a z3 busboard with a video slot activated with the microniks adaptors connected on the amiga chipset.The problem is that i dont remember if the scandoubler works in a micronik a1200 busboard video slot.In the early start up sequence i can see the id of a working c64/3d but all i get from the scandoubler is a black screen with active 31khz signal.So first of all i would like to ask you if anyone has used a micronik a1200 busboard with a phase5 scandoubler .thank you.
-
Dear Amijim of 2008 , i am Amijim of 2020 and i would like to remind you that there was the typical broken resistor of the scan doubler and you only had to solder a bridge over it.And yes the cybervision scan doubler works on a micronik busboard.